Custom height and width

[Siamat Profile Website]

Cant you get your Enemy Territory totally full screen because the height and width is just not in the resolution selection? Dont worry. Here you can enter your custom height and width.

Start Enemy Territory -> Open console -> Type in:

/set r_mode -1
/set r_customwidth xxxx
/set r_customheight xxxx
/set r_customaspect 1

When you done with typing in, close Enemy Territory and restart it. And for the people who are a bit confused. Here is what i had to type in to get it full screen on my computer.

/set r_mode -1
/set r_customwidth 1680
/set r_customheight 1050
/set r_customaspect 1

I hope that this is usefull to some people

[Death Profile]

If you install your ET isn't it immediatly at right wide and heigth?
It was with me. Maybe cause i have more standard screen...

[Samuraii Profile Website]

With alt+enter you can switch to 600x800 and alt+enter again = the height you used before .

[deep Profile]

With alt+enter you can switch to 600x800 and alt+enter again = the height you used before .

no, alt+enter minimizes (not fullscreen) and reso wont change

[Samuraii Profile Website]

hmm for me it does it changes from 1024 x 7** to 800x600

[nick Profile]

for me it switches from windowed to full screen?

[deep Profile]

for me it switches from windowed to full screen?

exactly

[Siamat2 Profile Website]

/bump

It's not bad